Maintenance96 97
4.4.1 CHECKING AND CLEANING THE
SEALING LIP FRAMES
Check the condition of the sealing lips regularly; if
required, remove fluff balls, hairs, etc.
REMOVING THE SEALING LIP FRAMES
In order to be able to clean the sealing lips thor-
oughly, the frames can be removed from the Kobold
SP600.
1. Place the SP600 upside down. Make sure that
the pivot is facing you.
2. Using gentle force, unlatch the left hand side
of the sealing lip frame and pull it upwards to
disengage
.
3. Then slide it out of its mounting on the right
hand side
.
4. If required, rinse the sealing lip frames under
running water.
MOUNTING THE SEALING LIP FRAMES
Before reattaching the sealing lip frames in the
device, they must have dried completely.
The two sealing lip frames are different in shape and
have to be fitted on different sides. The end-to-end
sealing lip of the frame must point inwards towards
the cloth.
1. Insert the sealing lip frame on the right hand
first
.
2. Then clip the left hand side into position .
Make sure that the pin is inserted into the in-
tended slot on the SP600.
4.4.2 CLEANING THE TANK
Rinse the tank regularly with clean water. If needed,
you can also rinse out the tank with a mild soap
solution.
1
2
2
1
1
1
2
2
To Next Page
Loading...
