Kobold VK200 - Page 64

Operation62 63
LED WAVE SYMBOLS AT A GLANCE
LED wave
symbol
Meaning
Dry mode
No waves
are lit.*
The SP600 is ready to use and is
running in dry mode, without
applying any moisture to the cloth.
* (The Kobold vacuum cleaner is
switched on and the
SP600 is running).
Moisture setting 1
One wave
lit.
The SP600 is ready for use, the
function key has been pressed
once, the SP600 applies moisture
to the cleaning cloth on the lowest
setting.
Moisture setting 2
Two
waves
lit.
The SP600 is ready for use, the
function key has been pressed
twice, the SP600 applies moisture
to the cleaning cloth on the medi-
um setting.
Moisture setting 3
Three
waves lit.
The SP600 is ready for use, the
function key has been pressed
three times, the SP600 applies
moisture to the cleaning cloth on
the highest setting.
Single application of moisture to a dry cloth
All three
waves
flashing.
The SP600 is ready for use, the
function key has been pressed
down and held, the SP600 makes
the cleaning cloth completely wet
in a single application.
All waves lit
up yellow.
The reservoir is empty.
All waves
flashing red.
The inspection flap comes open,
the SP600 has absorbed moisture
(see chapter “5 Troubleshooting” on
page 100).
All waves lit
up red.
The SP600 has detected a fault
(see chapter “5 Troubleshooting” on
page 100).
1
2
3
4
5