Kobold VK200 - Page 48

Operation46 47
CLEANING THE DOSAGE HOPPER
1. Remove any residue of Kobosan Active from the
dosage hopper by using, for example, the Flexo
Nozzle or Electric Suction Hose.
2. If it is very dirty, clean the dosage hopper under
cold or lukewarm running water.
3. In order to do so, take the dosage hopper
out
of the Carpet Freshener
.
4. Remove the cover .
The dosage hopper can only be removed
after dosage has been deactivated (see chapter
”3.2.3 Kobosan Active dosage” on page 43).
5. Remove the dosage roller
from the hopper.
However, this is only necessary if it is very dirty
(see chapter “4 Maintenance” on page 85).
6. Dry the dosage hopper and cover.
CLEANING THE BRUSH
1. Open the brush cover
on the underside of the
device by pressing from the side
.
2. Take out the brush and hold it on the side
with the pin
.
3. Rinse out the brush under cold or lukewarm
running water straight after every use. Make
sure that the pin does not come into contact with
water.
4. Shake excess water off the brush.
5. Once it has dried, reinstall the brush in the
Carpet Freshener (set onto the pin and swing in)
and close the brush cover on the device.
VF200
2
3
1
VF200
2
3
1
4