119
18.1 JOB Selection
· Before recording data, select the JOB in which it is to be recorded. The following data can be recorded in
JOB.
·Measurement results
·Instrument station data
·Notes
· A total of 24 JOBs have been prepared, and JOB01 was selected when your KTS-440 was shipped from
the factory.
· A total of 100,000 data items, which includes data stored in all JOBs and the coordinate data in the
memory, can be stored inside the instrument. Storage space for 2 items is required to store 1 item of
instrument station data.
PROCEDURE
Operating Procedure Operation Display
⑴ Select “1. JOB” in the “Memory Mode
Screen” and press ENT (or press numeric key 1),
the “JOB Management Screen” is displayed.
“1. JOB”
+
ENT
Mem./ JOB
1. JOB selection
2. JOB deletion
3. Comms output
⑵ Select “1. JOB Selection” then press ENT (or
press numeric key 1).
The 24 JOBs are divided among four pages,
The numbers to the right represent the number of
data items in each JOB.
“1. JOB
Selection”
+
ENT
Mem./ JOB
* JOB01 20
* JOB02 8
JOB03 10
JOB04 0
↑↓P TOP LAST EDIT
⑶ There are 2 kinds of working jobs in system:
current working job and read coordinate file.
Press ▲or ▼key to move the cursor onto the
file needs to be changed, press LIST key. All
jobs will be displayed in 4 pages, the numbers
on right side show the record amount.
▲
or
▼
+
List
JOB selection
* JOB01 20
* JOB02 8
JOB03 10
JOB04 0
↑↓P TOP LAST
EDIT
JOB selection
* JOB01 20
* JOB02 8
JOB03 10
JOB04 0
↑↓P TOP LAST
To Next Page
Loading...
Need help?
General
