118
PART 4 DATA RECORDING
·This section explains JOB or memory settings which can be performed in Memory Mode and data
recording methods which can be performed in Record Mode.
Memory Mode Screen
· To enter Memory Mode, press MEM in the “Status
Screen.”
Record Mode Screen
· To enter Record Mode, press REC in “MEAS Mode
Screen”.
·Press ESC to return to previous screen.
18 SETTING IN MEMORY MODE
Memory Mode Screen ·To enter Memory Mode, press MEM in the “Status Screen”
· In Memory Mode, it is possible to perform settings
concerning JOB and memory.
· JOB selection
· Deleting a JOB
· Registering Coordinate Data in Memory
Clearing Coordinate Data from Memory
· Reviewing Coordinate data
· Inputting codes
· Reviewing codes
· Outputting JOB data to the computer
Memory
1. JOB
2. Known data
3. Code
4. Define roads
5. Initialize
1. Dist data JOB01
2. Angle data
3. Coord data
4. Stn data
5. Note
6. View
Memory
1. JOB
2. Known data
3. Code
4. Define Roads
5. Initialize
To Next Page
Loading...
Need help?
General
