122
18.2 Deleting a JOB
· It is possible to clear the data within a designated JOB.
· It is not possible to clear a JOB until external output (transmission to the host computer or output to a
printer) has been completed.
An “*” beside a JOB name indicates that the data in that JOB has not been output.
· After the data has been cleared, the JOB name returns to the name allocated when the KTS was shipped.
PROCEDURE
Operating Procedure Operation Display
⑴ Select “1. JOB” in the “Memory Mode
Screen” and press ENT (or press numeric
key 1), the “Job Management Screen” is
displayed.
“1. JOB”
+
ENT
Mem./ JOB
1. JOB selection
2. JOB deletion
3. Comms output
⑵ Select “2. JOB deletion” and press ENT, the
JOB names are displayed in a table.
“2. JOB
deletion”
+
ENT
JOB deletion
* JOB01 20
* JOB02 8
JOB03 10
JOB04 0
↑↓P TOP LAST EDIT
⑶ Select the JOB whose data is to be deleted
and press ENT, the “JOB Deletion
Confirmation Screen” is displayed.
☆If the selected JOB data is not sent, it will
recommend you to send the JOB out,
Press ESC to exit, output the JOB and delete
it.
ENT
ESC
JOB deletion
JOB. JOB01
Deletion
Confirm？
NO YES
JOB deletion
Send first
Press ESC key
To Next Page
Loading...
Need help?
General
