134
18.12 Reviewing Codes
·It is possible to display a list of codes in memory.
PROCEDURE
Operating Procedure Operation Display
Selec⑴ t “3. Code” in the “Memory Mode
Screen” and press ENT (or press numeric
key 3), the “Code menu screen” is displayed.
“3. Code”
+
ENT
Mem./Code
1. Key in code
2. Code deletion
3. Code view
4. Clear list
⑵ Select “3. Code view” and press ENT (or
press numeric key 3). The “Code view
screen” is displayed.
“3. Code
view”
+
ENT
Code view
ABCDEFGHIJKLMNO
A001
TREE0LEET
POINT1 ↓
↑↓P TOP LAST
⑶Align the cursor with the code.
·Move item: ▲or▼
·Changing the cursor motion unit: ↑↓P
·When ↑↓P is displayed, the cursor moves from
line to line.
·When ↑↓P is displayed, the cursor moves from
page to page.
·Display top of code: TOP
·Display end of code: LAST
Press ESC to end operating and restore to
“Code Menu Screen.”
ESC
Mem./Code
1. Key in code
2. Code deletion
3. Code view
4. Clear list
●Road Design
Under memory mode it allows you to make road design, refer to “17.1 Road Design”.
18.13 Initialization
·This operation restores instrument parameters to factory default settings and clear alldata.
·Below settings will be restored by initialization.
① Observation:
Atmosphere correction, vertical angle format, tilt correction, measurement type, auto power off, coordinate
unit, minimim angle display, minimum distance display, keyboard buzzer, same (or different) result of
coordinate measurement by measuring with face left/ right.
To Next Page
Loading...
Need help?
General
