Konami KX43 - SECTION 2 Set-Up - Startup Procedures; LCD Unit and Operator Controls; Startup and Power Checks

SECTION 2 - SET-UP
-2-10
2-10 © 2018 Konami Gaming Inc P/N 810440
KX43
(Original Instructions)
43" lCd unit
The LCD displays animations, bonus games, and bonus pays
to the player� It is also accesses the KMS to display game
information, audit information, log les, game recall les, event
info les, and system info les. It is also displays diagnostic
screens and game test screens� All touch-based controls are
on the Touch Dash Panel�
ServiCe button
The SERVICE Button is used to illuminate the upper Signal
Tower light with a steady ash, indicating to the operator that
service is required at the machine�
CaShout button
The Cashout Button is used by the player to retrieve unused
credits from the machine� When pressed, the Hopper activates
the sound of dropping coins into the coin bowl, triggering an
attendant pay, printing a ticket or a combination of events�
SeleCt nuMber oF lineS buttonS
The SELECT LINE(s) Button allows the player to choose the
number of lines played�
SeleCt bet x per line buttonS
The Bet X Per Line Buttons allow the player to select the
number of credits played for each of the selected lines�
bet Max button
The BET MAX button wagers the maximum number of
credits for each time it is pressed� A credit equals the current
denomination times the maximum amount of coins that can
be bet (if the machine is optioned with a denomination of
50 cents, and the maximum number of coins is 45, the bet
max value would be $22�50)� When the BET MAX button is
pressed, the reels spin automatically�
STARTUP
Before plugging in the machine, check the following items�
inSpeCt Cabinet
• Check that all the units are plugged in rmly.
• Check that all the connectors are connected�
• Check that the AC cord is not damaged�
• Check that the Power Switch is in the OFF position�
• Check that fuses are not opened�
inSpeCt uSe environMent
• Check that the power supply meets the specication
for the cabinet�
• Check that the AC cord is not strained (do not bend
the AC cord at a sharp angle, coil it, or weigh it down)�
• Make sure that no water is near the power supply�
inSpeCt aFter ConneCting the aC plug to the
reCeptaCle
• Check that the smell of smoke is not present�
• Check that no sparks, smoke, or ame are produced.
• Check that the AC cord does not get too hot�
turning on the poWer SWitCh
The rst time you power on the game, you must complete a
RAM CLEAR procedure� Refer to the KP3�5 Setup Manual,
part number 810239�
kp3.5 Setup
To properly set up the game, refer to the KP3�5 Setup Manual,
part number 810239�