30/ENGINE - WORK ON INDIVIDUAL PARTS 121
18.28Installing rocker arm
300114-11
– Position the rocker arm and push in the rocker arm shafts .
Info
Make sure that the tapped hole of the rocker arm shaft is positioned facing
outwards.
The small drill hole and the flat surface must point upwards.
300113-11
– Install and tighten the screws of the rocker arm shafts.
Guideline
Screw, rocker arm shaft M6 12 Nm (8.9 lbf ft)
18.29Dismantling antihopping clutch
300120-10
– Clamp the clutch in a vise.
Info
Use soft jaws.
– Carefully loosen and gradually remove the special tool .
300121-10
– Take the clutch out of the vise and lay it on a clean workbench with the outer
clutch hub facing down.
– Take the inner clutch hub and release springs out of the outer clutch hub .
300122-10
– Take off the clutch disks from the inner clutch hub.
– Remove pretension ring and support ring .
– Clean all parts well.
– Check the clutch. ( p. 122)
To Next Page
Loading...
