30/ASSEMBLING THE ENGINE 132
19.1Installing transmission shafts
300087-10
– Clamp the right section of the engine case.
Holder for engine work stand (75012001070) ( p. 212)
Support for engine work stand (75012001060) ( p. 212)
Engine work stand (61229001000) ( p. 211)
– Make sure that both stop disks are installed.
– Mount the inner bearing race on the countershaft.
300088-10
– Lubricate all bearings.
– Assemble the two transmission shafts and slide them into the bearing seats
together.
300089-10
– Mount the upper shift fork , the middle shift fork , and the lower shift fork .
Info
For the assembly of the middle shift fork , the sliding gear of the
third/fourth gear must be lifted.
300090-10
– Insert shift drum into the bearing seat.
– Hang the shift forks into the shift drum.
300079-11
– Install the shift rail .
– Check the transmission for smooth operation.
300082-11
– Install the shim and lock ring of the countershaft.
To Next Page
Loading...
