07/FUEL TANK, SEAT, TRIM 54
10.1Opening filler cap
100227-10
– Lift the cover of the filler cap and insert the ignition key.
– Turn the ignition key 90° counterclockwise and remove the filler cap.
Info
The filler cap has a tank air vent system.
10.2Closing filler cap
100228-01
– Put the filler cap back on and turn the ignition key 90° clockwise.
– Remove the ignition key and fold down the cover.
10.3Removing the seat
100230-10
– Pull on strap and raise the rear of the seat at the same time.
– Pull back the seat and lift it off.
10.4Mounting the seat
100276-10
– Hook slot of the seat onto screw , press the rear downward and at the same
time push it forward.
– Push locking pin into lock housing and push the back of the seat down until
the locking pin locks in place with an audible click.
– Finally, check that the seat is correctly mounted.
10.5Taking off the side cover
– Remove the seat. ( p. 54)
300198-10
– Remove screws .
– Pull off the side cover in area and take off from above.
– Repeat the operation on the opposite side.
To Next Page
Loading...
