KTM 2008 690 SMC EU - Assembling the Damper

04/SHOCK ABSORBER, SWINGARM 41
7.19Assembling the damper
– Assemble the piston rod. ( p. 40)
300590-10
– Position membrane .
– Mount and tighten membrane cover .
– Mount lock ring .
300588-11
– Push the spring and sleeve onto the compression damping adjuster. Attach the pis-
ton.
– Mount and tighten the compression damping adjuster .
Guideline
Compression damping adjustment M26x1 30 Nm
(22.1 lbf ft)
300586-11
– Mount and tighten screw .
Guideline
Filling port screw M10x1 14 Nm
(10.3 lbf ft)
300592-10
– Fill the damper cartridge about half full.
Shock absorber oil (SAE 2,5) (50180342S1) ( p. 205)
300593-10
– Grease O-ring  of the seal ring retainer.
Lubricant (T158) ( p. 206)
– Mount the piston rod carefully.
300585-11
– Mount seal ring retainer  and push it under the ring groove.
– Mount lock ring .
Info
Do not scratch the inner surface.
– Pull out the piston rod so that the seal ring retainer rests against the lock ring.