05/EXHAUST 48
300208-11
– Position the spacer.
– Position the manifold at the front with the seals.
– Mount and tighten nuts .
Guideline
Nut, manifold on cylinder
head
M8 25 Nm
(18.4 lbf ft)
Copper paste
300209-12
– Position the exhaust clamp.
– Tighten screw .
Guideline
Screw, exhaust clamp on
manifold
M8 25 Nm
(18.4 lbf ft)
Copper paste
300210-11
– Plug in the connector of the lambda sensor . Secure the cable with the cable
binders.
300207-11
– Position the heat shield.
– Mount and tighten screws .
Guideline
Screw, exhaust heat shield M5 8 Nm (5.9 lbf ft)
– Install the air filter box. ( p. 52)
8.3Removing the main silencer
Warning
Danger of burns The exhaust system gets very hot when the vehicle is driven.
– Allow the exhaust system to cool down. Do not touch hot components.
302044-10
– Remove screws .
– Take off the exhaust heat shield.
To Next Page
Loading...
