07/FUEL TANK, SEAT, TRIM 55
10.6Mounting the side cover
300198-11
– Attach the side cover in area and engage it in area .
– Mount and tighten screws .
Guideline
Screw, side cover M5 2 Nm (1.5 lbf ft)
– Repeat the operation on the opposite side.
– Mount the seat. ( p. 54)
10.7Checking the fuel pressure
Danger
Fire hazard Fuel is highly flammable.
– Never refuel the vehicle near open flames or burning cigarettes, and always switch off the engine first. Be careful that no
fuel is spilt, especially on hot vehicle components. Clean up spilt fuel immediately.
– Fuel in the fuel tank expands when warm and can escape if the tank is overfilled. See the notes on refueling.
Warning
Danger of poisoning Fuel is poisonous and a health hazard.
– Avoid contact between fuel and skin, eyes and clothing. Do not inhale fuel vapors. If fuel gets into your eyes, rinse immedi-
ately with water and contact a doctor. Wash affected skin areas immediately with soap and water. If fuel is swallowed, con-
tact a doctor immediately. Change clothing that has come into contact with fuel. Store fuel in a suitable canister according
to regulations and keep it out of the reach of children.
Condition
The fuel tank is completely full.
The ignition is off.
The diagnostics tool is connected.
302037-10
– Press on the metal plate and disconnect the fuel hose connection .
Info
Remaining fuel may run out of the fuel hose.
400926-10
– Mount special tool .
Pressure testing tool (61029094000) ( p. 211)
– Mount special tool with nozzle code 0,60.
Testing hose (61029093000) ( p. 211)
– Insert the hose end in a fuel canister.
Guideline
Minimum fuel canister capacity 10 l (2.6 US gal)
– Switch on the ignition.
– Select model.
– Select "ECU Diagnostics".
– Highlight the "Injection management EFI LC4" control unit.
– Press "Continue".
– Select "Actuator test".
– "Please enter the password:"
– Press "Continue".
To Next Page
Loading...
