KTM 2008 690 SMC EU - Removing the Heim Joint

04/SHOCK ABSORBER, SWINGARM 38
300554-10
– Measure the diameter of the piston rod.
Piston rod
Diameter ≥ 17.95 mm (≥ 0.7067 in)
» If the specification is not reached:
– Change the piston rod.
– Measure the run-out of the piston rod.
Piston rod
Run-out ≤ 0.03 mm (≤ 0.0012 in)
» If the measured value is greater than the specified value:
– Change the piston rod.
– Check the piston rod for damage and wear.
» If there is damage or wear:
– Change the piston rod.
300460-01
– Check the heim joint for damage and wear.
» If there is damage or wear:
– Change the heim joint.
7.16Removing the heim joint
Condition
The shock absorber has been removed.
200577-10
– Clamp the shock absorber in the vise using soft jaws for protection.
– Remove collar bushing  of the heim joint.
Pin (T120) ( p. 217)
– Turn over the shock absorber and remove collar bushing  of the heim joint.
Pin (T120) ( p. 217)
200578-10
– Remove seal rings  on both sides.