04/SHOCK ABSORBER, SWINGARM 46
Guideline
Spring rate
Soft 80 N/mm (457 lb/in)
Medium (standard) 85 N/mm (485 lb/in)
Hard 90 N/mm (514 lb/in)
300581-11
– Tension the spring with the special tool.
Spring compressor (T101S) ( p. 217)
– Install the spring retainer .
The open end is opposite the spring end.
201331-10
Alternative 1
– Tension the spring to the prescribed amount by turning the adjusting ring.
Guideline
Spring preload 18 mm (0.71 in)
Hook wrench (T106S) ( p. 217)
Hook wrench (T157S) ( p. 219)
Alternative 2
Warning
Danger of accidents Modifications to the suspension settings can seri-
ously alter the vehicle's ride behavior.
– Extreme modifications to the adjustment of the spring elements can
cause a serious deterioration in the handling characteristics and
overload some components.
– Only make adjustments within the recommended range.
– After making adjustments, ride slowly at first to get the feel of the
new ride behavior.
– Tension the spring to the amount measured during dismantling by turning the
adjusting ring.
Hook wrench (T106S) ( p. 217)
Hook wrench (T157S) ( p. 219)
– Lock the retaining ring with the adjusting ring.
To Next Page
Loading...
