17. LIGHTS/ SWITCHES
17-2
MX’er SYSTEM
SERVICE INFORMATION
GENERAL INSTRUCTIONS
• An electric tester is needed to measure or test the electric equipment.
• Be sure to use fuses and bulbs of the same specifications to avoid damage of electrical
equipment.
• After installation of each switch, a continuity check must be performed. A continuity check can
usually be made without removing the part from the motorcycle.
TROUBLESHOOTING
Lights do not come on Engine starts but stalls during idling
when ignition switch is “ON” • Clogged carburetor
• Faulty ignition switch
• Fuse burned out
• Weak battery
• Burned bulb
• Faulty switch
• Poorly connected, broken or shorted wire
To Next Page
Loading...
