KYMCO MX 125 - Page 172

17. LIGHTS/ SWITCHES
17-4
MX’er SYSTEM
Remove the headlight bulb
INSTALLATION
Install the headlight in the reverse order of
removal.
INSTRUMENTS
REMOVAL
Remove the two headlight attaching bolts.
Remove the headlight and disconnect the
headlight wire coupler.
Remove the two headlight case attaching
screws and disconnect the headlight.
Remove the light shell, rubber boot and
bulb socket.
Check the bulb for damage and replace with
a new one if necessary.
INSTALLATION
The installation sequence is the reverse of
removal.
STOP LIGHT/TAILLIGHT
Remove the two taillight shell screws and
the shell.
Headli
g
ht Bulb
Li
g
ht Shell
Taillight Shell Screws
After installation, adjust the headlight
beam.

Bulb Socke
t
Rubber Boo
t
Taillight Shell