KYMCO MX 125 - Page 83

7. CYLINDER HEAD/VALVES
7-5
MX’er SYSTEM
Remove the four cylinder head nuts and
washers.
Remove the camshaft holder and dowel
pins.
Remove the camshaft gear from the cam
chain and remove the camshaft.
CAMSHAFT INSPECTION
Check each cam lobe for wear or damage.
Measure the cam lobe height.
Service Limits:
IN : 31.40mm replace if below
EX: 31.13mm replace if below
Cam Chain
Camshaft Gea
r
Camshaft Holde
r
Nu
t
Washe
r
Dowel PinsCamshaf
t
Diagonally loosen the cylinder head nuts
in 2 or 3 times.
