Disconnect the oil pump control cable from
the pump body.
Disconnect the oil inlet line from the oil
pump.
Remove the two carburetor lock nuts.
Remove the carburetor.
Remove the rear drive chain gear on the
bolts.
Remove the drive chain gear.
Remove the two nuts attaching the exhaust
muffler.
Remove the two nuts attaching the exhaust
pipe.
Remove the exhaust muffler lock bolts.
Remove the exhaust muffler and exhaust
pipe. (
!
2-5)
After the oil inlet line is disconnected,
plug the oil line opening to prevent oil
from flowing out.
To Next Page
Loading...
