1. GENERAL INFORMATION Movie S 125i
1-7
Route harnesses so they are neither
pulled tight nor have excessive slack.
Protect wires and harnesses with electrical
tape or tube if they contact a sharp edge or
corner.
When rubber protecting cover is used to
protect the wire harnesses, it shall be
installed securely.
Do not break the sheath of wire.
If a wire or harness is with a broken sheath,
repair by wrapping it with protective tape
or replace it.
W
hen installing other parts, do not press or
squeeze the wires.
Do not pull too
tight!
Do not press o
s
ueeze the wire.
To Next Page
Loading...
