1. GENERAL INFORMATION Movie S 125i
1-8
After routing, check that the wire harnesses
are not twisted or kinked.
Wire harnesses routed along with
handlebar should not be pulled tight, have
excessive slack or interfere with adjacent
or surrounding parts in all steering
positions.
When a testing device is used, make sure to
understand the operating methods
thoroughly and operate according to the
operating instructions.
Be careful not to drop any parts.
When rust is found on a terminal, remove
the rust with a sand papers or equivalent
before connecting.
Do not bend or twist control cables.
Dam
aged control cables will not operate
smoothly and may stick or bind.
Do you understand the
instrument? Is the
instrument set
correctly?
Remove Rust !
To Next Page
Loading...
