KYMCO SR25BA - Page 61

5. Fi INJECTION SYSTEM MOVIE S 125i
5-9
DTC Code List
Blink Failure
Codes
Fault description Priority Fault management
11 P0350 Ignition coil or electric
circuit malfunction
2
1. Check if the connector of ignition coil is loosen.
2. Check if the ECU send signal to Ignition coil.
3. Check if the power source and resistance is malfunction.
12 P0230 Fuel pump relay or electric
circuit malfunction
2
1. Check if the connector of relay is loosen.
2. Check if the ECU send signal to relay.
3.
Check the fuel pump relay resistance
13 P0219 Engine speed is over than
top speed
2 Check if the belt of CVT is broken.
14 P1560 Sensor don’t receive power
source from ECU
2
1. Check if ECU output DC5V to sensor.
2. Check if the power source of all sensor is DC5V.
3. Replace a new ECU if the CELP still blinks even the output power
source of ECU is normal.
15 P0700 Engine starting speed
exceed CVT speed limited
2
1. Check if the throttle wire locked.
2. Check if the position of throttle screw is correct.
3. Check if the belt of CVT is broken.
16 P0115
Engine temperature sensor or
electric circuit malfunction
2
1. Check if the connector of sensor is loosen.
2. Check if ECU pin is broken.
3.Check if the resistance of sensor is malfunction.
17 P1561 Temperature gauge electric
circuit malfunction
2 Don’t use it at present.