Operation on the Machine > Sending Document via E-mail
231
Sending Document via E-mail
NOTE
• When transmitting using wireless LAN, select the interface dedicated to the send function in advance.
➡ Primary Network (Client) (page 485)
• Before sending the scanned document with an E-mail, configure the SMTP and E-mail settings using the
Embedded Web Server RX.
➡ SMTP and E-mail Settings (page 111)
1
[Home] key > [Send]
2
Place the original.
➡ Loading Originals (page 208)
3
In the destination screen for sending, select [Enter destination] > [Email]
4
Enter destination E-mail address > [OK]
Up to 256 characters can be entered.
➡ Character Entry Method (page 734)
When selecting On for "Entry Check for New Dest.", the re-entering screen for the destination information
appears.
➡ Re-entering the New Destination (page 258)
To enter multiple destinations, select [Next Destination] and enter the next destination. Up to 100 E-mail
addresses can be specified.
You can register the entered E-mail address in the Address Book by selecting [Add to Address Book]. You
can also replace the information for a previously registered destination.
Destinations can be changed later.
➡ Checking and Editing Destinations (page 256)
NOTE
• If "Broadcast" is set to [Prohibit], multiple destinations cannot be entered.
➡ Broadcast (page 440)
To Next Page
Loading...
