Operation on the Machine > Handling Destination
258
Re-entering the New Destination
If the "Entry Check for New Dest." is set to on, the re-entering screen for the destination information is displayed.
➡ Entry Check for New Dest. (page 440)
Enter the same destination information again, and select [OK].
Recall
"Recall" is a function allowing you to send the last entered destination once again. To send to the same destination
again, select [Recall] to call the destination to the destination list.
1
Select [Recall].
The destination you sent is displayed on the destination list.
NOTE
When the last sending included FAX, folders and E-mail destinations, they are also displayed. If necessary,
add or delete the destination.
2
Press the [Start] key.
Sending starts.
NOTE
• If "Destination Check before Send" is set to On, the destination confirmation screen appears when the
[Start] key is pressed.
➡ Confirmation Screen of Destinations (page 257)
• Recall information is canceled in the following conditions.
- When you turn the power off
- When you send a next image (new recall information is registered)
- When you log out
To Next Page
Loading...
