Kyocera 458ci - Energy Saver;Timer

System Menu > DeviceSettings
406
Energy Saver/Timer
[System Menu/Counter] key > [DeviceSettings] > [Energy Saver/Timer]
[Auto Panel Reset]
If no jobs are run for a certain period of time, automatically reset settings and return to the default setting. Select
to use Auto Panel Reset or not.
Value: Off, On
NOTE
For setting the time until the panel is automatically reset, refer to the following:
➡ Panel Reset Timer (page 406)
[Panel Reset Timer]
If you select On for Auto Panel Reset, you can set the amount of time to wait before Auto Panel Reset.
Value: 5 to 495 seconds (in 5 second increments)
NOTE
This function is displayed when [Auto Panel Reset] is set to On.
[Sleep Timer]
Set amount of time before entering Sleep.
Value: 1 to 120 minutes (1 minute increments)
➡ Sleep (page 85)
[Sleep Rules]
Select whether to use the Sleep mode for the following functions individually:
This function will not be displayed when the optional Network Interface Kit or Fiery controller is installed.
• ID Card Reader
(Displayed when the optional Card Authentication Kit is activated.)
• Application
Value: Off, On
NOTE
If the sleep condition is not turned off, the ID card cannot be recognized.
[Weekly Timer Settings]
Configure settings for switching the machine into Sleep mode and waking it automatically at a specified time for
each day of the week.