System Menu > NetworkSettings
475
[IPP]
[IPP over TLS]
[HTTP]
[HTTPS]
Item Description
[Protocol Settings] Set whether to send documents using IPP. To use it, select On in these
settings, and select [Off] in [TLS] from "SecuritySettings". Then select
[Not Secure (IPPS & IPP)] in the security settings from Embedded Web
Server RX. The default port number is 631.
Value: Off, On, 1 to 32767 (Port Number)
[Available Network] Set whether to enable this function for each network of Wi-Fi Direct,
Wi-Fi and wired.
Value: [Disable], [Enable]
Item Settings
[Protocol Settings] Sets whether to receive documents using TLS-protected IPP. To use it,
select On in these settings, and select [On] in [TLS] from
"SecuritySettings". The factory default port number is 443.
*1*2
Value: Off, On, 1 to 32767 (Port Number)
NOTE
When the setting is On, TLS certificate is required. The factory certificate
is the certificate owned by the machine.
[Available Network] Set whether to enable this function for each network of Wi-Fi Direct,
Wi-Fi and wired.
Value: [Disable], [Enable]
Item Description
[Protocol Settings]
Set whether to communicate using HTTP.
*1
Value: Off, On
[Available Network] Set whether to enable this function for each network of Wi-Fi Direct,
Wi-Fi and wired.
Value: [Disable], [Enable]
Item Description
[Protocol Settings]
Select whether to communicate using HTTPS.
*1*2
Value: Off, On
[Available Network] Set whether to enable this function for each network of Wi-Fi Direct,
Wi-Fi and wired.
Value: [Disable], [Enable]
To Next Page
Loading...
