Installing and Setting up the Machine > Default Settings of the Machine
78
Wired Connection with LAN Cable Using Wi-Fi Setup Tool
To send the Wi-Fi settings configured in the Wi-Fi Setup Tool to the machine, connect the computer or mobile
device with the machine locally. To use a wired LAN cable directly connected to the machine, the Auto-IP
(Link-local) address will be assigned to the machine and the computer. This machine applies Auto-IP as the default
settings.
NOTE
Configure the settings on the operation panel if your computer supports WPS.
➡ Wi-Fi Settings (page 463)
➡ Wireless Network (page 481)
1
Connect the machine with a computer.
1 Connect the machine with a computer via LAN cable when the machine is powered on.
2 Turn on the computer.
IP addresses (link local addresses) of the machine and computer are generated automatically.
2
Launch the Wi-Fi Setup Tool.
1 Launch your Web browser.
2 Enter URL into the browser’s address bar or location bar.
Triumph-Adler
https://www.triumph-adler.com/ta-en-de/customer-service/download-centre
https://www.triumph-adler.com/ta-de-de/kundendienst/download-center
UTAX
https://www.utax.com/en-de/hardware/office-printer-and-mfp/download-centre
https://www.utax.com/de-de/hardware/buerodrucker-und-mfp/download-center
3 Follow the guidance on the screen to download the Wi-Fi Setup Tool.
4 Double-click the downloaded installer to launch.
NOTE
• Installation on Windows must be done by a user logged on with administrator privileges.
• If the user account management window appears, click [Yes] (Allow).
To Next Page
Loading...
