Installing and Setting up the Machine > Default Settings of the Machine
84
Configuring the Connection by Using Push Button
When your computer or mobile device does not support Wi-Fi Direct but supports WPS, you can configure the
network using push button.
1
Display the screen.
[System Menu/Counter] key > [NetworkSettings] > "Network Settings" [Wi-Fi Direct Settings]
2
Configure the settings.
"Wi-Fi Direct": On >[Close]
3
Restart the network.
[System Menu/Counter] key > [NetworkSettings] > "Network Settings" [Restart Network] > [Restart]
4
[Home] key > [DeviceInformation] > [Wi-Fi Direct/Wi-Fi]
5
Press the push button on the computer or mobile device and select "Wi-Fi Direct"
[Push Button Setup] > [OK] on the screen of operation panel.
The network between this machine and the computer or mobile device is configured.
IMPORTANT
You can connect up to 10 mobile devices at the same time using Wi-Fi Direct setting. When the devices that
support Wi-Fi Direct are connected, if you want to connect other device, disconnect the already connected
devices from the network. The disconnection methods are as follows:
• Disconnect the network from the computer or mobile devices
• Disconnecting all devices from the network on the operation panel
Select the [Home] key > [DeviceInformation] > [Wi-Fi Direct/Wi-Fi] > "Wi-Fi Direct" [Device] > [Disconnect]
> [Disconnect].
• Configuring auto disconnecting time from the System menu
➡ Wi-Fi Direct Settings (page 462)
• Configuring auto disconnecting time from the Embedded Web Server RX
➡ Embedded Web Server RX User Guide
To Next Page
Loading...
