3-2
Fax transmission > Basic transmission procedure
Basic transmission procedure
The basic procedure for using the fax system is explained below.
1
Select [FAX] on the Home screen.
The base screen for fax appears.
2
Place the originals.
For placing originals, refer to the following:
Machine’s Operation Guide
3
Select the transmission method.
There are two transmission methods: memory transmission and direct transmission.
Memory transmission: After originals are scanned into memory, the communication starts. Memory transmission
is selected by default.
Direct transmission: The destination is dialed and communication starts before the original is scanned.
Select [Direct] to change the transmission method to direct transmission. The key will be highlighted on the touch
panel. If the [Direct] is selected in the highlighted state, the transmission method will change to memory
transmission.
For operation of direct transmission, refer to the following:
[FAX Direct Transmission] (5-7)
4
Select the Destination.
Specify the transmission destination.
Methods For Entering the Destination (3-6)
5
Selecting the functions.
Select the tab, and set transmitting functions that can be used.
Fax transmission functions (5-3)
To Next Page
Loading...
