9-9
Optional Equipment > Using a Connected Telephone
Manual Reception
Reception is possible after confirming that the telephone line has connected to the sending party.
1
The telephone rings.
When there is an incoming call, the telephone connected to the machine makes a ringing tone.
2
Lift the handset.
Lift the optional handset or telephone.
3
Check if the telephone line has connected to the fax of the sending system.
If the destination is a fax machine, you will hear soft beep sounds. If a person answers, you can talk to that
person.
4
[FAX] on the Home screen > [On Hook] > [Manual RX]
Reception will start.
5
Replace the handset.
When reception starts (when the [Processing] indicator on the operation panel starts blinking), return the handset
to its original position.
To use Manual Reception, you need to change the receiving mode to [Manual Reception].
[Reception] (8-10)
When using a telephone set that can send tone signals, use the telephone to start the reception of originals with
the remote switch function.
Remote SW Dial (8-11)
To Next Page
Loading...
