3-4
Fax transmission > Basic transmission procedure
1
Select the [Status/Job Cancel] key.
2
Select the job to be sent by priority override.
1 Select [Sending Jobs].
2 Select the fax job to be sent by priority override and select [Menu] > [Priority Override].
The selected fax job is sent by priority override and other fax jobs are moved down in the transmission queue.
If a broadcast transmission job is in progress...
If a fax job to multiple destinations (broadcast transmission) is in progress, the priority override job will be sent
when transmission to the current destination is completed. When the priority override job is completed,
transmission to the remaining destinations will resume.
However, if the priority override job is a broadcast transmission, the priority override job will not start until the
current broadcast transmission job is finished.
Cancelling Memory Transmission (while originals are being
scanned)
1
Select the [Stop] key.
During memory transmission, to cancel scanning while originals are being scanned, select the [Stop] key on the
operation panel, or select [Cancel] on the touch panel. Scanning of originals is canceled, and the originals are
ejected. When originals remain in the document processor, take them out from the original output table.
Cancelling Memory Transmission (during communication)
1
Select the [Status/Job Cancel] key.
2
Canceling Transmission.
1 Select [Sending Jobs].
2 Select the transmission job that you want to cancel and select [Cancel] > [Yes]
Cancel the transmission.
Cancelling Transmission (Disconnection of Communication)
Follow this procedure to break the connection and stop communication.
If a fax job is in progress, the priority override fax job will be sent after the job in progress is completed.
Even if transmission is canceled, there is a possibility that pages scanned prior to cancelation were sent to the
receiving party. Check with the receiving party to see if pages were accidentally sent.
In some cases, transmission may take place even if the [Stop] key or [Cancel] is selected.
To Next Page
Loading...
