Section 7 COPIER MANAGEMENT
7-92
Repeat copying ON/OFF
Perform the following procedure to set whether or not to prohibit
repeat copying, as well as whether or not to make repeat copying
the default setting in the initial mode.
NOTE
This setting is displayed on duplex copiers or when the
optional Memory Copy Board is installed.
1
Display the “Copy default” screen.
(See “Accessing the copy default settings” on
page 7-66.)
Inch specifications
Metric specifications
2
Select “Modify Copy” under the “Default menu” column on
the left side of the touch panel and then press the “Change
#” key.
The “Modify Copy” screen will be displayed.
Inch specifications
Metric specifications
3
If you want to prohibit repeat copying, press the “Off” key.
If you want to make repeat copying the default setting in
the initial mode, press the “On” key.
Inch specifications
Metric specifications
NOTE
If you want to quit the displayed setting without changing
it, press the “Back” key. The touch panel will return to the
screen in step 2.
4
Press the “Close” key.
The touch panel will return to the screen in step 2.
5
Press the “Close” key once again.
The touch panel will return to the “Default setting” screen.
6
Press the “End” key.
The touch panel will return to the contents of the “Basic”
tab.
!
!
!!!
" "
"
!
" !
###
$ $
$
To Next Page
Loading...
