LaCie d2 Network 2 - Insert and Format the Disk(S)

d2, 2big, and 5big Network 2 User Manual 124
Flash red and blue. The red and blue lights indicate the system is loading.3.
The LaCie NAS is ready for disk installation once the front LED turns solid blue again.3.
Insert and format the disk(s)
Steps 4 through 6 should take approximately seven minutes.
Carefully insert the full drive tray into the empty Disk Slot 1. You will feel resistance when the drive tray is1.
most of the way in the bay. Gently push the drive tray handle firmly until you feel it snap into place. The
drive tray handle should be flush with the back of the enclosure.
If you are adding more than one disk, please insert full drive trays into empty slots in the enclosure. Make2.
certain to follow the slot numbers. For example, the second disk should be inserted into Disk Slot 2, the third
disk into Disk Slot 3, etc.
Use the drive lock tool to lock the tray(s) in place.3.
Press the front LED button for five seconds. The drive(s) will spin up and the front LED will blink blue4.
and red.
The NAS must reboot to complete the initialization. The front LED will blink red and blue.5.
The system is ready once the front LED turns solid blue.6.
Go to Connect to the Network.7.