LACO PROTOCOL DESCRIPTIONS TITANTEST™
139
© 2018 LACO TECHNOLOGIES, INC. - TitanTest itra01en1-07 SB.fm - 1807
*MEASure:SAVEDOFFset:M2 Saved leak rate offset for mass 2 517 R
*MEASure:SAVEDOFFset:M3 Saved leak rate offset for mass 3 517 R
*MEASure:SAVEDOFFset:M4 Saved leak rate offset for mass 4 517 R
*MEASure:TEMPeratur:Amplifier Preamplifier temperature [°C] 166 R
*MEASure:TEMPeratur:Electronic Electronic temperature [°C] 165 R
*MEASure:TEMPeratur:TCBearing TMP temperature bearing [°C] 145 R
*MEASure:TEMPeratur:TCElectronic TMP electronic temperature [°C] 144 R
*MEASure:TEMPeratur:TCMotor TMP motor temperature [°C] 146 R
*MEASure:TEMPeratur:TCPump TMP temperature bottom [°C] 143 R
*MEASure:TURBO:Current TMP current [A] 151 R
*MEASure:TURBO:Frequency TMP frequency [Hz] 138 R
*MEASure:TURBO:Power TMP power [W] 139 R
*MEASure:TURBO:Voltage TMP voltage[V] 150 R
*MEASure:UFB Remote control voltage [V] 212 R
*MEASure:UNV Amplifier voltage [V] 652 R
*MEASure:UOUT Voltage extern [V] 213 R
*MEASure:UVV Preamplifier voltage [V] 202 R
*READ Leak rate in selected unit 128 R
*READ:ATM*cc/s Leak rate in Atm*cc/s R
*READ:G/a leak rate in g/a (only in sniff) R
*READ:MBAR*l/s Leak rate in mbar*l/s 129 R
*READ:OZ/yr Leak rate in oz/yr (only vaild in sniff) R
*READ:PA*m3/s Leak rate in Pa*m
3
/s R
*READ:PPM Leak rate in ppm (only vaild in sniff) R
*READ:TORR*l/s Leak rate in Torr*l/s R
*STArt Start (switch from Standby to Measure) 1 W
*STATus Status of leak detector (INIT, ACCL, STBY, VENT, WAIT_EVAC,
EVAC, MEAS, CAL, ERROR)
Status
word
R
*STATus:CAL Calibration status:
"IDLE", "WAIT", "EVAC", "WAIT_TL_STABLE", "TUNE",
"TL_OPEN_ULTRA", "TL_OPEN_FINE", "TL_OPEN_GROSS",
"WAIT_CLOSE", "TL_CLOSE_ULTRA", "TL_CLOSE_FINE",
"TL_CLOSE_GROSS", "WAIT_RESULT"
260 R
*STATus:CALHist Calibration history 1 to 12 (date, time, type of calibration,
mode, calibration factors)
275 R
*STATus:CALMode Kind of calibration (AUTO, MANUAL, EXTERNAL) --- R
Command Meaning
Relates to
LD cmd. no.
Read/Set
To Next Page
Loading...
