ECO GOLD
25/08/2011/ YACE0088 Appendix with settings 103
G Interface modules
G.1 Menu structure of the modules
From this overview all menu points which cannot be executed in practice are masked out.
off
on
no
Yes Set-point temperature
Calibration external actual temperature
Factory calibration Pump power
Status
Job function Voltage 0-10V
closed Interface type Current 0-20mA
open minimal value Current 4-20mA
Menu automatic maximal value
Calibration off
on
Analog Input 1
Analog Input 2 Status Set-point temperature
Analog Output 1 Job function Controlled temperature
Analog Output 2 Interface type Internal temperature
Modules minimal value Temperature extern Pt100
maximal value Temperature extern analog
Calibration Temperature extern serial
Set value
Pump power
RS 232 Pump speed
RS 485
extern Pt100 Voltage 0-10V
Cooling valve Current 0-20mA
Analog Interface 2400 Current 4-20mA
serial interface Mode 4800
Switch.contacts Baud rate 9600 off
RS 485 address 19200 Fault
Standby
Programmer
Input 1 Job function Change mode
Input 2 Contact open Control mode
Input 3 Contact closed
Output 1 Contact open intern Pt100
Output 2 Contact closed extern Pt100
Output 3 extern analog
extern serial
Job function
Diagnostics off
Temperature range Error diagnosis
Standby
temperature range
Programmer
Control mode
All Messages
Low level
Overtemperature
Errors only
To Next Page
Loading...
Need help?
General
