Lauda E 4 G - A.7 Entering the offset of the displayed temperature (calibration)

ECO GOLD
84 Appendix with settings 25/08/2011/ YACE0088
A.6 Limiting the mains current consumption
If your mains fusing is below 16 A, the current consumption can be reduced in steps from 16 A to 8 A.
The maximum heating power is reduced correspondingly. Here, take into consideration whether other
loads are connected to the same fused circuit or whether your ECO thermostat is the only load.
− Access to the main menu level is obtained by pressing the
enter key
.
− Selection and confirmation of Æ Setup Æ
Basic setup.
The adjacent menu window appears.
− As well as Curr.Consumpt. the set value is displayed.
− Select Curr.Consumpt. with .
− Change the value with
or .
− Single figures can be selected by pressing
or .
− Confirm the input with the enter key
.
− By pressing
(ESC) you are returned to the menu level without any change.
A.7 Entering the offset of the displayed temperature (calibration)
Deviations to the calibrated reference thermometers (e.g. LAUDA DigiCal) can be corrected internally
by the "Offset" function.
− Access to the main menu level is obtained by pressing the
enter key
.
− Selection and confirmation of Æ Setup Æ Calibration.
The adjacent menu window appears.
− Select Calibration with or and confirm with .
The entry window appears. The value indicated on the refer-
ence thermometer must be entered as the value.
− Change the value with
or .
− Single figures can be selected by pressing
or .
− By pressing
(+/-) the arithmetic sign can be changed.
− You confirm the set value by pressing
.
− By pressing
(ESC) you are returned to the menu level without any change.
ESC
סּ OK
Standby
Basic setup
Acoustic signal ►
Display ►
Autostart on►
Resolution
Curr.Consumpt. 16.0A
DLK connected
ESC
סּ OK
Standby
Curr.Consumpt.
Max: 16.00
Min: 8.00
16.00
ESC
סּ OK
Standby
Calibration
Calibration .
Factory calibration
ESC
סּ OK
+/-
Temp. ref. meas. device
Max:28.16
Min:-22.16
25.16