ECO GOLD
25/08/2011/ YACE0088 Before putting the device into operation 37
− Touch the bare earthed stainless steel back panel of the ECO thermostat to discharge any electro-
static charge.
− Remove the module from the packaging.
− Switch off the thermostat and withdraw the mains plug.
− The plastic cover has a recess on each side to ease
removal.
Insert a screwdriver first in the right and then in the left
recess of the plastic cover and carefully lever it up.
− Pull the bus connecting lead out of the plastic cover.
− Plug in the bus connecting lead (red plug in the red
socket).
− Introduce the module into the appropriate receptacle
and fasten it using the two cross-head screws.
− Insert the mains plug again and switch on the thermo-
stat.
The connectors have reverse-polarity protection. The plug
has a projection which slides into a notch on the socket.
To Next Page
Loading...
