ECO GOLD
52 Maintenance 25/08/2011/ YACE0088
When the bath temperature is located above the overtemperature
switch-off point, a two-tone alarm sounds. "Overtemperature" ap-
pears in the display, the heater switches off on all poles and the
pump and chiller are switched off via the electronics.
− Rectify the cause of the malfunction.
− Wait until the bath temperature has cooled below the overtem-
perature switch-off point or set the overtemperature switch-off
point higher than the bath temperature.
If "Overtemperature" appears in the display:
− Unlock the "Overtemperature" display with
.
No. Alarm
3 Overtemperature
3 Overtemperature
Display
סּ OK
Standby
To Next Page
Loading...
