3-32 Developed for Training Purposes Leerjet 35/36
February 1998
CAE SimuFlite
The following products have been qualified for blending MIL-I-
85470 additive over-the-wing:
Q
Hi-Flash Prist 20 fluid ounce aerosol blender.
Q
D-Ice Flash 190, 20 fluid ounce aerosol blender.
Biocide Additive
BIOBOR JF is approved for use as a biocide additive when pre-
mixed in the fuel supply facility. Concentration is not to exceed
270 ppm.
Aviation Gasoline
Aviation gasoline (MIL-D-5572D, Grades 80/87, 100/130, and
115/145) may be used as an emergency fuel and mixed, in any
proportion, with various approved jet kerosene-based fuels.
Aviation gasoline may not be used in excess of 500 gallons per
100 hours of operation per engine.
CAUTION: Ensure that anti-icing additive is directed into the
fuel stream and that additive flow starts after fuel flow starts
and stops before fuel flow stops. Do not allow concentrated
additive to contact interior of fuel tank or aircraft painted sur-
faces.
WARNING: Anti-icing additive may be harmful if inhaled or
swallowed. Use adequate ventilation. Avoid contact with
skin and eyes. If sprayed into eyes, flush with large amounts
of water and contact a physician immediately.
CAUTION: Drain all sumps prior to refueling with fuel con-
taining Biobor JF.
To Next Page
Loading...
