Leerjet 35/36 Developed for Training Purposes 6-9
February 1998
Servicing
The following products have been qualified for blending MIL-I-
85470 additive over-the-wing:
Q
Hi-Flash Prist 20 fluid ounce aerosol blender.
Q
D-Ice Flash 190, 20 fluid ounce aerosol blender.
Biocide Additive
BIOBOR JF is approved for use as a biocide additive when pre-
mixed in the fuel supply facility. Concentration is not to exceed
270 ppm.
CAUTION: Ensure that anti-icing additive is directed into the
fuel stream and that additive flow starts after fuel flow starts
and stops before fuel flow stops. Do not allow concentrated
additive to contact interior of fuel tank or aircraft painted sur-
faces.
WARNING: Anti-icing additive may be harmful if inhaled or
swallowed. Use adequate ventilation. Avoid contact with skin
and eyes. If sprayed into eyes, flush with large amounts of
water and contact a physician immediately.
CAUTION: Drain all sumps prior to refueling with fuel con-
taining Biobor JF.
To Next Page
Loading...
