Measuring Mode Softkey Description
VA/ZA Set vertical angle to Horizon = 0°.
Set vertical angle to Zenith = 0°.
Distance Measurement Meas To execute a distance measure-
ment and store the displayed val-
ues.
Dist To execute a distance measure-
ment.
Store To save the displayed values
without executing a distance
measurment.
EDM Enter EDM settings.
OffSet Enter offset function.
SetOut Enter Set Out app.
Coordinate Measurement Meas To execute a distance measure-
ment and store the displayed val-
ues.
Dist To execute a distance measure-
ment.
Store To save the displayed values
without executing a distance
measurment.
EDM Enter EDM settings.
hr Enter target height.
hi Enter station height.
STN Enter station coordinates.
Backsight Enter the back-sight orientation
program
OffSet Enter offset function.
4.5.2 Angle Measurement
1. Power on to enter the standard survey interface.
2.
Press
button on the keyboard.
1. Align to the rst target A.
2. Press Hz=0 to set the horizontal angle to 0°0’0’’.
3. Press YES.
4. Align to the second target B to read the horizontal and vertical
angles between B and A.
By locking the angle
1. Rotate the angle by the horizontal drive.
2. Press Lock to x the horinzontal angle.
3. Align to the target.
Access
Measure horizontal
and vertical angles
between two points
Set an angle
32 Operation
To Next Page
