Leica TS01 - Page 60

2. Select Resection.
Key Description
Value To select a point from the memory.
Meas.A To measure only the angle.
Meas To execute a distance measurement and store the displayed
values.
To calculate and display the station coordinates, if at least
two points and a distance were measured.
Coord To enter point coordinates manually.
OK To accept the selection.
1. Press Value to select a point from the memory.
OR
Press Coord to enter point coordinates manually.
2. Press OK to accept the selection for the rst point.
3. Repeat 1. and 2. for the following points.
At least three points are required.
4. Before starting the measurements:
Press OK to nish the selection and start measuring.
5.
☞
Meas is available after the selection of the second point.
Align to the target and press Meas.
When distance is surveyed, the angle is surveyed as well.
6. Press YES to accept the measurement.
Press NO to repeat the measurement.
7. Repeat the measuring steps for all selected points.
8. Press CAL to calculate and display the station coordinates.
Key Description
AddPT To add more points and to return to the input screen.
STN To set as the station point which is not saved.
Store To save and set as the station point.
To display the next valuesl.
Description of elds
Field Option Description
PointID: Display only The name of the result point.
hi Display only Instrument height
E : Display only Easting coordinate of the centre point.
N : Display only Northing coordinate of the centre point.
Z : Display only Height of the point measured with the
reector.
dE: Display only Computed residual for the Easting coordin-
ate.
Enter values
Results
60 Apps