EasyManuals Logo

LELY WELGER RPC 445 TORNADO User Manual

LELY WELGER RPC 445 TORNADO
144 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #107 background imageLoading...
Page #107 background image
FIELD DEPLOYMENT
LELY WELGER y RPC 445 Tornado 99
9.16 Removing a material jam
Attention, danger of injury!
Malfunctions on the draw-in elements (e.g. pick-up, draw-in
screws and tine rotor) may only be remedied after
disconnection of the control electronics from power supply
(interrupt electric connection to tractor), when the tractor
motor has been stopped and the ignition key removed!
On machines with cutting device there is danger of injury by
knives when working in the feed channel. Wear always
protective gloves!
Note!
About "Material jam" see:
y
chapter Material Jam / Feed Guide Plate, page 87.
y
chapter Elastic suspension of the feed channel floor
HYDROFLEXCONTROL, page 98.
The feed channel floor HYDROFLEXCONTROL can be opened
hydraulically to increase the clearance below the feed rotor
considerably (Figure 87). In this way, jammed material is drawn
through easier, grasped by the bottom baling roller and
conveyed into the baling chamber.
Note!
See separate operating manual "PRO-LINK for RPC 445",
chapter "Bottom door".
Figure 87

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the LELY WELGER RPC 445 TORNADO and is the answer not in the manual?

LELY WELGER RPC 445 TORNADO Specifications

General IconGeneral
BrandLELY WELGER
ModelRPC 445 TORNADO
CategoryFarm Equipment
LanguageEnglish

Related product manuals