SAFETY
LELY WELGER y RPC 445 Tornado 27
3.11 Net Knife Safeguard
When maintenance and assembly work is being carried out in
the vicinity of the net knife, the net knife must be mechanically
secured against accidental falling down: Insert net knife
safeguard!
(Figure 12) fit and secure safety chain with spring clip.
After completion of maintenance and assembly work:
Remove safety chain.
3.12 Film Knife Cut Protection
When maintenance or assembly work is carried out in the
vicinity of the film knives, the two film knives must be covered
by the protection hoods included in the delivery.
(Figure 13) Cover the left and right film knives by a
protection hood. Secure the protection hoods using split
pins.
After completion of maintenance and assembly work:
remove the two protection hoods.
Figure 12
Figure 13
To Next Page
Loading...
Need help?
General
