COMMISSIONING
58 LELY WELGER y RPC 445 Tornado
7.13 Inserting the Net
Note!
Optimum results in production during use of our machines
depend of multiple factors. Therefore:
y Use high-quality nets.
y Heed and follow the instructions given in the operating
manuals. For working in extreme ambient conditions:
request to our customer service.
y See chapter "TECHNICAL DATA", page 34.
Attention, danger of injury!
Prior to inserting new net rolls and threading the net: stop
machine, switch-off power take-off shaft and tractor motor,
take out ignition key and wait for standstill of the machine.
Disconnect control electronics from power supply
(disconnect electrical connection to the tractor).
There is danger of injury by cutting during work on the net
knife. Wear protective gloves.
In order to handle the net roll safely, insert it together with
the help of a second person!
îî Open left side cover (lift up).
Attention, danger of injury by net knife turning
down automatically!
Only if the last wrapping process has not been completely
executed (e.g. because the net roll depleted during the
wrapping process): (Figure 37) Pull the handle of the knife
carrier hard to the front against the spring tension (the
triangular counting segment for the net length returns to its
starting position).
This prevents unexpected activation and automatic drop-
down of the net knife during threading of the net.
Figure 37
To Next Page
Loading...
Need help?
General
