LELY WELGER RPC 445 TORNADO User Manual

CUTTING DEVICE
68 LELY WELGER y RPC 445 Tornado
8 CUTTING DEVICE
8.1 General Information
The cutting device (Figure 58) can be used for silage, hay and
straw. The knives of the cutting device are swivelled in and out
hydraulically.
Attention, danger of injury!
Prior to any work on the cutting device of the machine:
Switch off power take-off shaft, switch off tractor engine,
remove ignition key and disconnect drive shaft from power
take-off shaft end. Disconnect electronics control from power
supply (disconnect electrical connection to the tractor).
8.2 Definition: Knife Groups
To change the cut length of the material to be pressed, knife
groups can be selected (that means, not all knives of the cutting
device are in use):
The cutting device XtraCut 25 (25 knives) contains a 12-knife
group and a 13-knife group (12 + 13 = 25). Both knife groups
can be used in the following combinations:
0 knives – 12 knives – 13 knives – 25 knives
Figure 58

LELY WELGER RPC 445 TORNADO Specifications

General

Brand	LELY WELGER
Model	RPC 445 TORNADO
Category	Farm Equipment
Language	English