MAINTENANCE BALER
106 LELY WELGER y RPC 445 Tornado
10.10 Winter pause
Prior to a winter pause:
Place the machine on an even surface to avoid frame
tension.
Remove net and straw remains from the machine.
Remove the net.
Thoroughly lubricate all bearings.
Remove, grind and reinstall cutting device knives.
Slightly grease the surface of the baling chamber by means
of a lubricant degrading neither the environment nor the
fodder (e.g. rape oil).
Check air pressure of tires and adjust – if necessary –.
Disconnect PRO-LINK control box from the machine (pull
off the plug) and store it at room temperature.
Drain compressed air storage tank of compressed air
braking system.
(See also: chapter "Winter pause", page 127.)