MAINTENANCE BALER
LELY WELGER y RPC 445 Tornado 103
10.4 Maintenance platform
Attention, danger of falling!
Never step on the maintenance platform while machine is in
motion. Before stepping on the maintenance platform: stop
machine, switch-off power take-off shaft and tractor motor
and wait for standstill of the machine.
10.5 Screw check
Note!
After the first 20 running hours: retighten all fastening screws
and nuts of the machine. Adjusting screws must not be
changed.
After the first 20 running hours:
Retighten all fastening screws and nuts – also inside the
machine –. Exception: do not change any adjusting screws.
10.6 Tensioners
Note!
(Figure 91) The gears [2] of the main drive shaft [1] are
mounted with tensioners to the shaft end. Working at the
tensioners [3] must only performed by instructed technical
staff.
Figure 91
Figure 90