Toinstalla3.5-inchsimple-swapharddiskdrive,completethefollowingsteps.
Step1.Unlocktheleft-sidecover.
Note:Youmustunlocktheleft-sidecovertoopenorremovethebezel.Whenyoulocktheleft-side
cover,itlocksboththecoverandthebezel.
Step2.Openthebezel(see“Openingthebezelmediadoor”onpage181).
Step3.Removethefillerpanel,ifoneispresent.
Step4.Touchthestatic-protectivepackagethatcontainsthediskdrivetoanyunpaintedmetalsurfaceon
theserver;then,removethediskdrivefromthepackageandplaceitonastatic-protectivesurface.
Step5.Grasptheblackdrivehandleandslidethebluereleaselatchtotherightandalignthedrive
assemblywiththeguiderailsinthebay.
3.5-inch
simple-swap
hard disk drive
Filler panel
Drive handle
Release latch
Figure119.Simple-swapharddiskdriveinstallation
Step6.Gentlypushthedriveintothebayuntilthedrivestops.
Step7.Closethebezel(see“Closingthebezelmediadoor”onpage183).
Step8.Locktheleft-sidecover.
Ifyouhavereplacedaservercomponentorinstalledanoptionaldeviceintheserver,youneedtoreconnect
thepowercordsandallexternalcables,andturnontheserverandperipheraldevices.
RemovingaDVDdrive
UsethisinformationtoremoveaDVDdrive.
Readthesafetyinformationin“Safety”onpagevand“Installationguidelines”onpage35.
Ifyouarereplacingaservercomponentintheserver,youneedtoturnofftheserverandperipheraldevices,
anddisconnectthepowercordsandallexternalcables.
ToremovetheDVDdrive,completethefollowingsteps.
Step1.Unlockandremovetheleft-sidecover(see“Removingtheleft-sidecover”onpage184).
Step2.Openthebezel(see“Openingthebezelmediadoor”onpage181).
Chapter6.Removingandreplacingcomponents205